7 Small Changes You Can Make That'll Make A Huge Difference In Your Pe…

Peugeot 308 Key Fob Replacement

Peugeot's 308 may be slightly old, but it is still attractive. It's not the most luxurious vehicle in its class, but it's a relaxing and civilised drive.

Here at Coded Car Keys we are often asked to replace peugeot 308 key fobs. Whether the problem is constant or intermittent the following suggestions should help.

Water Damage

If you accidentally drop your key fob into a puddle, or if it is soaked while kayaking, canoeing, rafting, or canyoning, the fob is likely to be damaged by water. The best way to stop this from happening is to always keep it in a dry bag when you're going outdoors or doing activities where the fob could be exposed to high levels of water.

You should also make sure that the fob is dry prior to opening it and re-using it. If you notice any odors coming from the fob, like an industrial-like liquid smell or the scent of windshield washer fluid, it's another indication that it's been submerged in water.

A wet circuit may cause the battery's charge to be drained or even explode. If you can pull the 308 keyfob from the water and turn it upside up and shake as much water as you can before opening the casing. Once you have opened it, take off the battery, and then clean the circuit board with an abrasive soaked in 90-percent isopropyl alcohol.

Other reasons why your Peugeot 308 remote keyless entry system could not function include the battery of your coin is dead or receiver module issues, signal interference, or an electronic chip that is defective. If none of these are the issue you can reset the system by disconnecting the 12 volt battery from your vehicle for 15 minutes.

Dead Coin Battery

Peugeot cars come with a remote-start feature that allows the driver to start the car from afar and then warm up or cool down the car prior to entering. This feature is extremely helpful, especially during cold winter months. However, sometimes the remote start system ceases working due to a variety of reasons, such as the battery in the coin is dead.

A coin-shaped battery located inside the key fob can last for a period of between two and four years, based on how frequently it is used and where it's purchased. The date of use is typically printed on the package or listed in the instruction manual.

If the key fob is no longer working after exposure to pure tapwater, you need to remove the battery and clean the electronic chip with the help of a paper towel that has been soaked with isopropyl ethanol. Then dry the chip thoroughly before replacing. If the key fob was exposed to soapy or salty water, it may have caused the chip to be damaged. It is necessary to replace it.

If you're unsure if the battery is in good condition You can test its voltage using a multimeter set to your car's voltage range, and connect it to the plus and minus terminals. The voltage should range from 12-13 volts, however, if it reads lower, then the battery needs to be replaced. You can also reset your computer onboard by disconnecting and reconnecting the 12 volt batteries in reverse order. (positive cable first, then negative cable). The engine should start.

Faulty Receiver Module

If you're unable to see the "Key Detected" message on your dashboard, then it's possible that your receiver module has discovered a problem. It's that part that sends a signal to the car when your key fob is activated which also acts as an immobiliser, and stops it from starting unless the key that you want to use is present.

This could be caused by a number of reasons, such as water damage or just ageing. If your Peugeot 308 key fob has been exposed to dirty tap water, for instance the electronic chip located inside is damaged. In this case you'll have to take it apart and clean it thoroughly with isopropyl alcohol or an electronic cleaner. Once it's dry you can put the battery back in and try again.

If the issue continues to persist, it is a good idea to consult an area Peugeot expert or locksmith. They can utilize a diagnostic tool in order to identify the issue and fix it.

Losing your Peugeot 207 Replacement key fob car keys could be a stressful experience. However, a trained auto locksmith can resolve the problem in minutes. They can program your car and cut a fresh, functioning key for you. Click here to find a local locksmith near you.

Faulty Electronic Chip

The electronic chip that is in your peugeot 307 key programming 308 key fob is a very important part of the remote control system. If the chip is damaged, you could be unable to start your car or get a message saying "anti-theft". In this instance the only option is to replace the key. Auto locksmiths who are professionals are able to provide this service in the shortest time.

The chip inside your Peugeot 308 key fob can be damaged by water damage, sweat, dirt or other reasons. If your Peugeot key fob has been exposed dirty or soapy water, it should be cleaned immediately. You can employ a paper towel as well as isopropyl alcohol to clean the electronic component. After that, you should let the battery completely dry.

Sometimes the key fob may cease to function due to radio interference. This is usually caused by other devices operate on the same frequency as your Peugeot keyfob. This could be due to unsafe conditions or objects that are near to the vehicle. If you experience this problem you should visit a Peugeot dealership.

The Peugeot 207/308 key fob is extremely delicate and requires care. It is crucial not to throw or drop the key fob. If you lose it, try to locate it as soon as you can. You can reset the onboard computer by disconnection of the battery for a few minutes. Disconnect the negative cable before the positive.